Preparing your maker experience...
DigitalDragon72
@thefreeheathen has his Worker Bots. Apparently my store has the Titan3D Nuggets (Minions). These little suckers ran amuck throughout the shop over the weekend. Mrs. Dragon had fun chasing them all over the place!
44 minutes ago
DigitalDragon72
We also worked on the Casadio Unimog build on Saturday night's stream (and some off camera building on Sunday). All three axles are almost done with only the steering setup (servo install) required on the Front and Third axle. I appears that I failed to properly read the instructions and installed the wrong portal axle steering nuckles on the front axle. Once I swapped them out everything was lining up properly.
about 1 hour ago
DigitalDragon72
We have been working hard getting the new store up and running and helping our community find new ways of using 3d printing in their lives. We have also been printing some cool models to show off around the store.
about 1 month ago