Preparing your maker experience...
DigitalDragon72
We also worked on the Casadio Unimog build on Saturday night's stream (and some off camera building on Sunday). All three axles are almost done with only the steering setup (servo install) required on the Front and Third axle. I appears that I failed to properly read the instructions and installed the wrong portal axle steering nuckles on the front axle. Once I swapped them out everything was lining up properly.
about 1 hour ago
DigitalDragon72
I've been busy in the shop working on a pair of Elegoo Centauri Carbons with failed CANVAS upgrades. I believe I have one working reliable well, while the other is ... kinda working with lots of intervention. I also streamed Saturday morning my build of the Titan3D Rebel (X-Wing) that I printed at 150% on my Qidi Max 4. This thing is HUGE!
about 1 hour ago
DigitalDragon72
We have been working hard getting the new store up and running and helping our community find new ways of using 3d printing in their lives. We have also been printing some cool models to show off around the store.
about 1 month ago