I have been modeling a MicroJig push block and it is coming along very well! Just a fe…
By What2Print
Posted
Category: tools-workshop
I have been modeling a MicroJig push block and it is coming along very well! Just a few minor adjustments like thicken up the bolt hole on the handle and offset a few faces so it prints well. Tpu on the feet took about 4 adjustment prints to get a tight fit. I was thinking about putting this on Printables but will probably get some low ratings if their printer doesn't print like mine. It takes a little bit to get TPU to print well sometimes. I don't want that so i probably won't. I wonder if this current legal action against Makerworld about copyrights will have a larger effect against a lot of the models we post.
1 image attached
3 likes · 0 comments
